KiteModeler
KiteModeler was developed in an effort to foster hands-on, inquiry-based learning in science and math. KiteModeler is a simulator that models the design, trimming, and flight of a kite. The program works in three modes: Design Mode, Trim Mode, or Flight Mode. In the Design Mode (shown below), you pick from five basic types of kite designs. You can then change design variables including the length and width of various sections of the kite. You can also select different materials for each componen
Author(s): No creator set

License information
Related content

Introduction

We have seen that where precipitation reaches the ground, some runs off the surface into streams and rivers and some of it infiltrates, passing through the soil. Water that reaches the water table to become groundwater may eventually re-emerge at the surface as springs where the water table intersects the surface. Almost all streams and rivers have springs or seepages as their ultimate source, or are fed by them at various points along their courses.

This unit is from our archive and is
Author(s): The Open University

License information
Related content

Copyright © 2013 The Open University

AP Environmental Science: Mastering the Math Part I

Video link (see supported sites below). Please use the original link, not the shortcut, e.g. www.youtube.com/watch?v=abcde